
HOVERYZE ep.8 Aluminum origami. In the process of bending the shell of the rear part
Updated: Jul 13, 2018

The most difficult part of my project. Creating back shell. A lot of aluminum is spoiled. But the back shell are partially ready.
Everything is hand-cut from 1.5 mm aluminum. Bent with the help of this type of bending machine.

Fuel tank
Lower air intakes
Rear plating
Partially assembled. The left part is more ready than the right one. Of course, the screws will be the same and more stylish. Now - all the fasteners are temporary.
Good quality 25cm riser came from China