Tankian Desk - Polyester, Sanding, Primer
Hi everyone! Well after 3 week I have news about the project, I manage to sand all the wood and metal pieces to apply the primer and even make some "upgrades" to the project concept.
So first I had to apply all the polyester in the areas needed, I even had to apply it more thant one time in the same place, something I expect but took me a bit more time to set everything ready to primer the desk. After aplying it in some areas I decide to make a rim all arround the top area to give a bit more resistance to the desk and provide a better surface for the glass, at the same time providing a trim all around the center "hole" to place some LED if needed. Then was time to apply once again polyester in some areas to make everthing look better. After sanding and applying the primer I realise something was a bit miss align in for the glass so before painting and get mad about the miss align thing yesterday I decide to correct it, I applied again primer to the front section and order the glass!
Let see how thing went!
Polyester and sanding
Water Cooling "ideas"
Small correction I did
So any thoughts about it?
Next phase is basicly make small holes for any cable I need to pass to the back of the case and starting to sand again for painting! Anyways there is still a lot to do but with time and patience thing will ne finish!
Best Regards tankian!